How to clean your computer: cleaning and laying of cables

How to clean your computer? Start with a shot of peripheral devices. With the help of air from the spray Blow space dust. In order not to rotate the fan blade during cleaning it is enough to insert the blade into the pencil or pen. Start cleaning the inside with better RAM slots. Direct the jet of air from the cylinder to the slot – blow it out as follows; We treat all slots.

Next blow cooler CPU and power supply to clean the fan blades can be used cloth or clean brush from cosmetic mascara. It is necessary to clean all the fans, as well as ports and components. When this stage is finished, pay attention to the lower part of the body – blow it, in extreme cases, wipe it with a slightly damp (not wet) cloth.

Inside many self-assembled computers often reigns chaos due to misfolded cables. Correct placement will provide freer movement of air masses inside the body, as well as to avoid unwanted contact between the fan cables. To avoid errors, pre-paint on the cable connections, then start them off. You will need collars, their length should be sufficient to embrace all of the cable. Next, perform the following:

– Compact group the one or more cables;
– Wrap-around collar;
– Tip push through the clip;
– Fasten tightly, pulling the end, then cut it.
Repeat this process as many times, and then connect the cable to the appropriate connector – use harvested scheme. Then return to the place of the removed all peripherals – modules of RAM, video card, etc.

After cleaning overheating problems remain in the past. To maintain the performance of the machine at the proper level, do not forget to repeat this procedure. If for you it seems too difficult, the Center computer support specialists are always ready to help you.
——-

Leave a Reply

Your email address will not be published. Required fields are marked *